Toshiba e-STUDIO281c Service Manual page 366

(6) Insert a flat-head screwdriver into the slit of
the fuser belt guide on the rear side. Then
slide the plate while opening the slit by the
flat-head screwdriver. Take off the fuser belt
guide from the fuser roller.
Note:
Be careful not to scratch the fuser belt.
(7) Remove 2 screws and take off the bracket.
(8) Take off the fuser roller.
(9) Remove 1 C-ring, 1 bearing and 1 fuser belt
guide from the fuser roller front side.
Note:
When installing, make sure that the fuser belt
guide securely fits in the fuser roller groove.
Also, make sure that the ring on the fuser
belt guide securely fits in the groove on the
belt restricting plate.
e-STUDIO281c/351c/451c
FUSER UNIT / PAPER EXIT SECTION
Screw
Bracket
Fuser roller
Fuser belt guide
Bearing
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
16 - 24
Fuser belt guide
Fig. 16-25
Screw
Fig. 16-26
C-ring
Fig. 16-27