Disassembly And Replacement - Toshiba e-STUDIO200L Service Manual

10.4 Disassembly and Replacement

[A] Main motor
(1) Take off the SYS board case
( P.2-46 "[D] SYS board case").
(2) Disconnect 1 connector. Remove 2 screws,
release 2 locking support, and then take off
the main motor.
[B] Main motor drive unit
(1) Take off the process unit
( P.11-8 "[A] Process unit").
(2) Take off the SYS board case
( P.2-46 "[D] SYS board case").
(3) Take off the connecting port cover
( P.2-37 "[O] Connecting port cover").
(4) Remove 1 screw and take off the flywheels.
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Screw
Screw
Connector
Fig. 10-3
Flywheel
Fig. 10-4
e-STUDIO200L/202L/203L/230/232/233/280/282/283
10 - 5
Main motor
DRIVE SYSTEM
10