Toshiba e-STUDIO200L Service Manual page 304

(5) Pull out the upper heater lamp and the lower
heater lamp.
Notes:
1. When installing the heater lamps, do not
mix up the upper side and lower side. The
upper heater lamp has the coil wound up
on its center part and the lower heater
lamp has the coil wound up on its both
ends.
2. Install the heater lamps on their welded
sides on upper.
3. Do not touch the lamps directly with bare
hands.
4. Distinguish the harnesses by their termi-
nals:
The M3 one is for the center heater lamp
and the M4 one is for the side heater
lamp.
[E] Fuser roller
(1) Take off the center heater lamp and side
heater lamp
( P.13-13 "[D] Heater lamp").
(2) Take out the fuser roller upward.
Notes:
1. When installing the fuser roller, move the
bearings on both ends outward so that
the bearings will be engaged into the
frames.
2. Be careful not to deform the fuser roller
by pushing strongly.
e-STUDIO200L/202L/203L/230/232/233/280/282/283
FUSER UNIT
Center heater lamp
Side heater lamp
Upper side : center heater lamp
Lower side : side heater lamp
Bearing
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
13 - 14
Fig. 13-14
Weld
Fig. 13-15
Fuser roller
Bearing
Fig. 13-16