Toshiba e-STUDIO200L Service Manual page 138

No. Message
24 Close Large Capacity
Feeder
25 Close Large Capacity
Feeder Door
26 Place Doc. Feeder in the
down position
27 Insert key copy counter
28 Place originals in the docu-
ment feeder
29 Change direction of original Displayed when the direction of origi-
30 PRESS [BASIC] and select
normal paper size
31 %d originals are scanned
Start copy job from next
page
32 Add paper
33 Cannot duplex this size
34 Cannot use this media type Displayed when the paper size which
35 Set standard size
36 Cannot staple this paper
type
37 Cannot duplex copy
38 Cannot use transparency
film
39 Copy size: A4/LT only
40 Copy size: A4/LT and A4-
R/LT-R
41 CHANGE DRAWER TO
CORRECT PAPER SIZE
42 Change the paper type
43 Select a paper size for
bypass feeding
e-STUDIO200L/202L/203L/230/232/233/280/282/283
CONTROL PANEL
State of equipment
LCF drawer is not installed when
feeding from LCF is set
LCF cover is open when feeding from
LCF is set
RADF is open when original is placed
on RADF
Key copy counter not inserted
Displayed when the conditions are
set and START button is pressed
with no original placed
nal placed is different from the setting
Displays the warning that the copy is
not enabled when any drawer but
bypass feed is selected at Cover
Sheet Copying Mode or Sheet Inser-
tion Mode
Paper jam occurred during copying
(RADF scanning)
Displayed when the paper in
selected drawer is running out
Displayed when the paper size which
is not specified for duplex copying is
set
is not specified for the functions such
as stapling or hole punching is set
Displayed when the paper size which
is not acceptable is set (depends on
the setting)
Displayed when the paper type which
can not be stapled is set at Cover
Sheet Copying Mode/Sheet Inser-
tion Mode
Displayed when the paper type which
can not be duplexed is set at Cover
Sheet Copying Mode/Sheet Inser-
tion Mode
Displayed when the paper type which
can not be punched is set at Cover
Sheet Copying Mode/Sheet Inser-
tion Mode
Displayed when the paper size which
is not specified for "Book-type duplex
copying" or "Dual-page" is set
Displayed when the paper size which
is not specified for "Rotate Sort"
Displayed when the selected paper
size is not in the drawer
Displayed when the selected media
type is not in the drawer
Displayed when paper size needs to
be specified for bypass feeding such
as duplex copying
5 - 4
Cleared by installing LCF drawer
Cleared by closing the cover
Cleared by closing RADF
Cleared by inserting key copy
counter
Cleared by setting the original
Re-set the paper size
Re-set the paper type
Re-set the paper type
Re-set the paper type
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Note