Toshiba e-STUDIO200L Service Manual page 232

[T] Tray drive unit / Tray-up motor
(1) Take off the SYS board case
( P.2-46 "[D] SYS board case").
(2) Take off the right rear hinge cover
( P.2-39 "[Q] Right rear hinge cover").
(3) Remove 4 screws and disconnect 1 connec-
tor. Release the harness from 2 harness
clamps and take off the tray drive unit with
the bracket.
(4) Remove 2 screws and take off the bracket
fixing the PCI slot.
(5) Remove 4 screws and take off the tray drive
unit from the bracket.
(6) Place the unit with its coupling up and
release 6 latches to take off the cover.
Note:
Be careful in taking off the cover because
there is a spring in the tray drive unit.
e-STUDIO200L/202L/203L/230/232/233/280/282/283
PAPER FEEDING SYSTEM
Tray drive unit
Connector
Tray drive unit
PCI slot bracket
Cover
Coupling
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
9 - 26
Harness clamp
Fig. 9-45
Fig. 9-46
Coupling
Spring
Spring
Fig. 9-47