Toshiba e-STUDIO200L Service Manual page 307

(3) Take out the thermistor by removing 1 screw
each.
Note:
When installing the thermistors, check the
length of the harness first and distinguish the
installation positions of the side thermistor
and edge thermistor by the length of each
harness.
[I] Thermostat
(1) Take off the pressure roller
( P.13-15 "[F] Pressure roller").
(2) Place the fuser unit upside down. Release
the latch and take off the harness cover.
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Thermistor
Fig. 13-23
Side thermistor
Center thermistor
Fig. 13-24
Harness cover
Fig. 13-25
e-STUDIO200L/202L/203L/230/232/233/280/282/283
13 - 17
Edge thermistor
FUSER UNIT
13