Toshiba e-STUDIO200L Service Manual page 169

4) The original size is determined by the combination of the signals output from each detection point.
Combination charts for size determination of A4 series and LT series are as follows.
[A4 Series]
Size judgement APS-C
A3 0
A4 0
B4 0
B5 1
A4-R 0
A5 1
B5-R 0
A5-R 0
[LT Series]
Size judgement APS-C
LD 0
LT 0
LG 0
LT-R 0
ST 1
ST-R 0
Code Output signal
1 H
0 L
* When the platen sensor is OFF,
• The following is judged by the signals output from the APS sensors.
- Size determined (The combination of the signals satisfies any in the above chart.)
: The size is displayed on the control panel and a specific paper size or reproduction ratio is
selected.
- Size not determined (The combination of the signals does not satisfy any in the above chart.)
: The size of the original immediately before the output signal change (or the state that there
is no original) remains.
- No original (The output signals from all sensors are level "H".)
: The reproduction ratio and paper size are not selected.
• The size change is always observed and detected.
• The carriage-1 stays at the waiting position even if the reproduction ratio changes corresponding
to the change of the original size.
* When the platen sensor is ON,
The size of the original immediately before the platen sensor is turned ON (or the state that there is
no original) remains regardless of the output signals of APS sensors.
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
APS-R APS-1
0 0
1 0
0 0
1 0
0 1
1 1
0 1
1 1
APS-R APS-2
0 0
1 0
0 1
1 1
1 1
1 1
Original
Not available
Available
6 - 15
APS-2 APS-3
0 0
0 0
1 0
1 0
1 0
1 0
1 1
1 1
APS-3
0
0
0
0
0
1
e-STUDIO200L/202L/203L/230/232/233/280/282/283
6
SCANNER