Toshiba e-STUDIO200L Service Manual page 305

(3) Remove 1 C-ring and 1 bearing from the
fuser roller front side.
(4) Remove 1 C-ring, 1 gear and 1 bearing from
the fuser roller rear side.
[F] Pressure roller
(1) Take off the fuser roller
( P.13-14 "[E] Fuser roller").
(2) Place the fuser unit with the pressure roller
on its bottom. Remove 2 screws and take off
the fuser unit entrance guide.
Note:
Install the fuser unit entrance guide by fixing
the screws in the holes marked by the
arrows. However, if paper wrinkling occurs
during duplex copying, use the holes not
marked by the arrows to reduce this.
(3) Take off the pressure roller. Remove 2 E-
rings and the bearings on both ends of the
pressure roller.
Note:
The pressure roller is quite heavy. Do not
drop the roller when lifting up.
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Bearing
C-ring
Fig. 13-17
Fig. 13-18
Pressure roller
Bearing
E-ring
Fig. 13-19
e-STUDIO200L/202L/203L/230/232/233/280/282/283
13 - 15
06/09
C-ring
Gear
Bearing
Fuser unit entrance guide
Bearing
E-ring
FUSER UNIT
13