[D] Lens unit
(1)
Take off the lens cover
(
P.6-18 "[B] Lens cover").
(2)
Disconnect 1 connector form the SLG board.
(3)
Remove 2 screws and take off the lens unit.
Notes:
1. When installing, fix the lens unit with the
screws while pushing the unit to the rear
side.
2. Refer to "3.7.2 Lens Unit" in the Service
Handbook for the adjustment method.
3. Never attempt to loosen the screws (8
pc.) of the lens unit denoted with arrows.
4. Handle the unit with extra care. Do not
touch the adjusted area or lens. (Hold the
unit as shown in the figure at right.)
e-STUDIO200L/202L/203L/230/232/233/280/282/283
SCANNER
Lens unit
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
6 - 20
Fig. 6-26
Fig. 6-27
Fig. 6-28