Toshiba e-STUDIO200L Service Manual page 216

[D] Paper feeding
• Lower drawer
- The feed clutch and transport clutches (upper, lower) are turned ON, and the pickup roller,
feed roller and transport roller rotate to start paper feeding.
- The leading edge of paper turns the 2nd transport sensor ON, and the feed clutch is turned
OFF. (Pick-up roller and feed roller stop rotating.)
- The leading edge of paper turns the registration sensor ON and the paper is aligned by the
registration rollers.
- The transport clutch (upper, lower) are turned OFF, and the transport roller stop rotating.
- The registration clutch and transport clutch (middle) are turned ON, and the paper is trans-
ported to the transfer unit.
• Upper drawer
- The feed clutch is turned ON and the pickup roller and feed roller rotate to start paper feeding.
- The leading edge of paper turns the registration sensor ON, and the paper is aligned by the
registration rollers.
- The feed clutch is turned OFF and the pickup roller and feed roller to stop rotating.
- The registration clutch is turned ON, and the paper is transported to the transfer unit.
e-STUDIO200L/202L/203L/230/232/233/280/282/283
PAPER FEEDING SYSTEM
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
9 - 10