Toshiba e-STUDIO200L Service Manual page 140

No. Message
65 Updated the template set-
ting
66 Enter Department Code
67 Cannot copy
Check DEPARTMENT
COUNTER
68 Not enough memory to
store original(s)
Will you print out stored
originals?
69 Not enough memory to
store original(s)
Will you enable stored orig-
inals?
70 Not enough memory to
store original(s)
Will you save stored origi-
nals?
71 The number of originals
exceeds the limits Will you
copy stored originals?
72 The number of originals
exceeds the limits.
Will you enable stored orig-
inals?
73 The number of originals
exceeds the limits.
Will you save stored origi-
nals?
74 Install new toner cartridge
75 Time for periodic mainte-
nance
76 Please try again after a
while
77 Misfeed in copier
78 Call for service
79 Cannot use envelope
80 Size must be ENVELOPE;
Type is ENVELOPE
81 Type must be ENVELOPE;
Size is ENVELOPE
82 Press START button to
copy after changing setting
e-STUDIO200L/202L/203L/230/232/233/280/282/283
CONTROL PANEL
State of equipment
Displayed when the template stored
is recalled by pressing [TEMPLATE]
button
Displayed when a button is pressed
while the department management
setting is available
Displayed when the number of print-
outs exceeds the limit number of
department counter
Displayed when confirming the user
to print out the data as much as
stored at memory-full state
Displayed when confirming the user
to send the FAX data as much as
stored at memory-full state
Displayed when confirming the user
to save the scanning data as much
as stored at memory-full state
Displayed when confirming the user
to print out the data as much as
stored at memory-full state
Displayed when confirming the user
to send the FAX data as much as
stored at memory-full state
Displayed when confirming the user
to save the scanning data as much
as stored at memory-full state
No toner in the cartridge
PM cycle
• Displayed at the time for mainte-
nance
• Copying is available
Displayed when the Department
Code can no be keyed in immedi-
ately after power-ON.
Paper jam in the equipment
• Displayed when paper jam
occurred in the equipment
Displayed when motor, sensor,
switch, etc. do not work properly
Displayed when envelope cannot be
set for duplex copy
Displayed when envelope is set for
media type, but not for the size of the
paper
Displayed when envelope is set for
the size of the paper, but not for the
media type
Displayed when the build job is set
5 - 6
Displayed only in FAX Function
Displayed only in Scanning Function
Displayed only in FAX Function
Displayed only in Scanning Function
Displayed when toner is running out.
Copying not enabled
Maintenance and inspection are per-
formed by qualified service techni-
cian
Leave it for a while and key in the
code again
Remove the paper in the equipment
according to the messages displayed
on the panel
Turn OFF the power and solve the
problem, then turn ON the power.
Re-set
Re-set the paper size
Re-set the media type
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Note