Toshiba e-STUDIO200L Service Manual page 223

[F] Bypass feed clutch
(1) Take off the bypass feed unit
( P.9-13 "[B] Bypass feed unit").
(2) Remove 1 clip. Take off the bypass feed
clutch together with the bushing and bracket.
[G] Bypass unit
(1) If the ADU is not installed, take off the right
front hinge cover, the right rear hinge cover
and the bypass upper cover
( P.2-38 "[P] Right front hinge cover",
P.2-39 "[Q] Right rear hinge cover",
39 "[R] Bypass upper cover").
If the ADU is installed, take off the ADU
( P.15-10 "[A] Automatic Duplexing Unit
(ADU)").
(2) Open the side cover.
(3) Disconnect 2 connectors. Remove 5 screws
and take off the bypass unit.
Note:
Make sure to let the disconnected connector
(A) (harness) through the hole (B).
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Bypass feed clutch
Bushing
Clip
P.2-
e-STUDIO200L/202L/203L/230/232/233/280/282/283
9 - 17
04/09
Bracket
Fig. 9-20
A
B
Bypass unit
Fig. 9-21
PAPER FEEDING SYSTEM
9