Toshiba e-STUDIO200L Service Manual page 127

(B) Pick-up failure in bypass (
• During bypass feeding
Bypass feed clutch ON
1st transport sensor is not turned ON in a fixed period of time
Clear paper symbol is displayed (
Copying operation is disabled
Solution: The bypass paper sensor is turned OFF by removing the paper from the bypass tray.
(C) Set key copy counter
• When the key copy counter (optional) is pulled out from the equipment which installs it:
"Set key copy counter" displayed
Copying operation disabled
• When the counter is pulled out during copying:
Copying is stopped when the key copy counter is pulled out.
"Set key copy counter" displayed
Copying operation disabled
(D) Misfeed in equipment (
• Exit sensor detects jamming of the leading edge of paper.
Registration clutch ON
Less than 1.808 sec.
Exit sensor ON
If the exit sensor is not turned ON after 1.808
sec,
Paper jam (E010)
is stopped.
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
)
): E120
)
The copying operation
4 - 9
Registration clutch
Exit sensor
Timer
0
Fig. 4-1
e-STUDIO200L/202L/203L/230/232/233/280/282/283
ON
ON
1.808sec.
Paper jam (E010)
GENERAL OPERATION
4