Toshiba e-STUDIO200L Service Manual page 179

Notes:
1. When installing the carriage-1, fix the
bracket temporarily at the position (A).
Then move it to the direction (B) slowly,
push it to the end of frame and fix at this
position with the screws.
2. Refer to the "3.7.1 Carriages" in the Ser-
vice Handbook
3. Rotate the drive pulley to move the car-
riage.
[G] Mirror-1
(1) Take off the carriage-1
( P.6-22 "[F] Carriage-1").
Note:
When replacing the mirror-1, replace it
together with the carriage-1. The mirror-1
should not be removed separately.
[H] Inverter board
(1) Take off the carriage-1
( P.6-22 "[F] Carriage-1").
(2) Disconnect 2 connectors.
(3) Remove 2 screws and take off the inverter
board.
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Bracket
Bracket
Fig. 6-41
Fig. 6-42
e-STUDIO200L/202L/203L/230/232/233/280/282/283
6 - 25
( A )
( B )
( A )
Inverter board
SCANNER
6