Toshiba e-STUDIO200L Service Manual page 178

Notes:
Be sure to install the lamp harness by follow-
ing the procedure below.
1. Using alcohol, clean the area where the
seal is to be attached.
2. Align the black line on the lamp harness
with the position as shown in the figure,
and fix it with a seal.
3. Align the bent portion of the lamp harness
with the position as shown in the figure,
and fix it with a seal.
4. After the installation, move carriage-1
towards the left and confirm that there is
no abnormality in the lamp harness, such
as twisting.
(6) Rotate the carriage-1 in the direction shown
in the figure at right, not to touch the mirror.
Then take out the carriage-1.
e-STUDIO200L/202L/203L/230/232/233/280/282/283
SCANNER
Lamp harness
Black Line
Hole
Punched mark
Lamp harness
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
6 - 24
07/03
Lamp harness
Seal
Fig. 6-38
Seal
Punched mark
Fig. 6-39
Carriage-1
Fig. 6-40