Toshiba e-STUDIO200L Service Manual page 181

[J] Mirrors-2 and -3
(1) Take off the carriage-2
( P.6-26 "[I] Carriage wire / Carriage-2").
Note:
When replacing the mirrors-2 and -3, replace
them together with the carriage-2. The mir-
rors-2 and –3 should not be removed sepa-
rately.
[K] Platen sensor
(1) Take off the rear cover an upper rear cover
( P.2-31 "[C] Rear cover",
Upper rear cover").
(2) Disconnect 1 connector from the platen sen-
sor on the left rear position of the equipment
upper side.
(3) Release the latches of the sensor and take
off the platen sensor.
[L] Carriage home position sensor
(1) Take off the rear cover upper rear cover
( P.2-31 "[C] Rear cover",
Upper rear cover").
(2) Disconnect 1 connector from the carriage
home position sensor on the left rear position
of the equipment upper side.
(3) Release the latches of the sensor and take
off the carriage home position sensor.
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
P.2-34 "[I]
Platen sensor
P.2-34 "[I]
6 - 27
Fig. 6-46
Carriage home position sensor
Fig. 6-47
e-STUDIO200L/202L/203L/230/232/233/280/282/283
6
SCANNER