Lower Laminator Transport Rollers
Removal Procedure
1.
Turn off the printer and unplug the power cord.
2.
Remove the
(page 6-38).
3.
Remove the
(page 6-97).
4.
Remove the
5.
Turn the laminator chassis upside down.
6.
Optional: For easier access, remove the
from the laminator.
7.
Remove the laminator entry and exit idler rollers:
A.
B.
CP80 and CP80 Plus Service Manual
Main Enclosure
Laminator Transport Assembly
Lower Foil Drive Assembly
Simultaneously pull the shaft to the left and the chassis wall toward the
right (as viewed in the photograph).
When the tip of the shaft clears the pocket in the chassis, lift the shaft out.
Be careful not to pull so hard on the chassis wall that you break the
chassis.
(page 6-15) and the
Upper Printer Assembly
from the base and control board
(page 6-128).
Lower Heater Assembly
(page 6-125)
6-101