Upper Foil Index Sensor
Removal Procedure
1.
Turn off the printer and unplug the power cord.
2.
Remove the
3.
Remove the
4.
Disconnect the sensor cable from the laminator control board.
5.
Gently pry against the bottom of the sensor body to free it from the chassis.
Replacement Notes
•
Make sure the sensor is fully seated and locked into position.
•
Refer to the
Connection Diagram
•
Print several laminate test cards to verify that the sensor is functional.
CP80 and CP80 Plus Service Manual
Main Enclosure
(page 6-15).
Upper Printer Assembly
Laminator Front Wire Routing Diagram
for replacement details.
(page 6-38).
and
Laminator Cable
6-115