Duplex Home Sensor
Removal Procedure
1.
Turn off the printer and unplug the power cord.
2.
Remove the ribbon cartridge and cleaning roller.
3.
Remove the
4.
Disconnect the sensor connector from the duplex interface board.
5.
Carefully push the sensor out of the duplex chassis.
Replacement Notes
•
When pushing the sensor into the duplex chassis, do not push against the wires
or crush them.
•
Print a test card to verify that the duplex is functioning properly.
CP80 and CP80 Plus Service Manual
Main Enclosure
(page 6-15).
6-75