Power Supplies - DataCard CP80 Plus Service Manual

Power Supplies

The same procedure is used for all three power supplies. Refer to the
Supply Wire Routing Diagram
connections, and wire routing information.
Removal Procedure
1.
Turn off the printer and unplug the power cord.
2.
Remove the
3.
Disconnect the DC power cord from the control board.
4.
Disconnect the AC power cord from the power supply.
5.
Remove first the horizontal hook and loop strap and then the vertical strap
by lifting the end of the strap and feeding it back through the eyelet.
6.
Lift the power supply out of the base.
Replacement Note
When replacing the horizontal strap, make sure the strap confines the power
cords snugly.
6-98
(page 6-10) for power supply placement,
Main Enclosure (page 6-15).
Power
Removal and Replacement