Pick; Transport; Flipper; Ymcwhiteshade - DataCard SD260 Installation And Administrator's Manual

YMCPowerNosRGB—Modify the intensity when you are printing without the sRGB color

mode.
Increase the value to make the non‐sRGB color darker

Decrease the value if using non‐sRGB color mode to prevent overly dark printing or

ribbon wrinkles or tears.
YMCWhiteShade—Modify the amount of power applied to the printhead to reduce ribbon

friction without transferring material. Decrease the value if unprinted or white areas of the
card have color applied to them and should not.

Pick

The Pick settings define how cards are picked from the input hopper. Pick settings are available
for WebService access‐level users only. Contact your service provider for information about
changing the printer's pick settings.

Transport

The Transport options allow you to set values for card travel through the printer.
Description
1) EjectHopperSpeed
2) TransMedSpeed
Change the settings as needed, and then click Set Current to apply the changes.
EjectHopperSpeed—Optimize the card eject speed based on the hopper type.

Select Standard if the printer has a standard output hopper.

Select Extended if the printer has an extended (100‐card) output hopper.

If you have installed the 100‐card output hopper, change the EjectHopperSpeed
setting to Extended to allow completed cards to stack properly in the hopper.
TransMedSpeed—The speed at which the transport motor runs when clearing errors. You

cannot change this value.

Flipper

The Flipper settings define values for the duplex module in duplex‐option printers. Flipper
settings are available for WebService access‐level users only.
50
Default Value Current Value (unit)
Standard Standard
800 1500
Allowed Range
StepsPerSecond [300 – 1800]
Printer Manager