Lower Heater Assembly
Removal Procedure
1.
Turn off the printer and unplug the power cord.
2.
Remove the
3.
Remove the
4.
Remove the
(page 6-97). (This includes disconnecting all of the cable connectors.)
5.
Disconnect the two wires from the heater lift motor.
6.
Free the wires from their cable guides.
7.
Gently pry the two retaining tabs away from the heater assembly and slide
the assembly up to remove it.
Follow-up Procedure
•
Make sure the motor wires are connected properly. Reversing the wires will
reverse the rotation of the motor. The polarity is shown above.
•
Refer to the
Routing Diagram
•
Print several test cards.
CP80 and CP80 Plus Service Manual
Main Enclosure
(page 6-15).
Upper Printer Assembly
Laminator Transport Assembly
Laminator Cable Connection Diagram
for replacement details.
(page 6-38).
from the base and control board
and
Laminator Rear Wire
6-125