Swingarm Assembly
Removal Procedure
1.
Turn off the printer and unplug the power cord.
2.
Remove the ribbon cartridge and cleaning roller.
3.
Remove the
4.
Optional: If the swingarm needs to be fully removed from the printer, it will
be necessary to remove the printhead cable.
A.
B.
C.
D.
E.
5.
Unhinge the swingarm by pulling each side off the hinge pins.
Replacement Note
Replace the cable tie if it was cut free.
•
•
Refer to the
6-7.
CP80 and CP80 Plus Service Manual
Main Enclosure
Remove the
Upper Printer Assembly
6-38).
Disconnect the printhead power and data cable connectors from the main
control board.
Cut the cable tie near the ferrite bead.
Disconnect the printhead fan connector from the main control board.
Pull the cables back through the cable guides in the transport chassis.
Print Engine Duplex and Printhead Wire Routing Diagram
(page 6-15).
from the interstage platform (page
on page
6-23