Transport Assembly
This is a general procedure for removing the transport assembly from the printer.
This procedure is a prerequisite to many other procedures.
If you are performing this procedure to access a component, you may want to
consider disconnecting only those cables necessary to turn the transport on
its side. This reduces the number of connectors needed to be re-connected on
the control board.
Removal Procedure
1.
Turn off the printer and unplug the power cord.
2.
Remove the ribbon cartridge and cleaning roller.
3.
Remove the
4.
Press in on the transport chassis locking tabs, and lift up on the back of the
transport assembly.
6-40
Main Enclosure
(page 6-15).
Removal and Replacement