DataCard CP80 Plus Service Manual page 106

Option
Printer | Motor Tests
Printer | Motor Cycle Tests
Printer | Step Test
Magnetic Stripe | Test Card
Magnetic Stripe|Configuration
Magnetic Stripe| Diagnostics
Smart Card | Test Card
Laminator | Values
Laminator | Sensor Display
Laminator | Motor Tests
5-8
This option allows you to operate each of the motors in the
printer for a specified duration as described in Testing Motors.
This option is for selecting a motor to test by having it complete
a full cycle of operation as described in Testing Motor Functions.
This option runs routines from the printer's firmware. Each routine
can be run individually or as a series of successive routines as
described in Setting Up Step Tests for the Printer.
This option provides access to printing test cards for the
magnetic stripe module. Only Advanced Users can read cards.
This option for configuring the magnetic stripe module is
available only to the Advanced User. It is for configuring Start
Sentinels, etc. as described in Configuring the Magnetic Stripe.
This option provides access to functions for troubleshooting the
magnetic stripe module.
The smart card test is a built-in routine to simulate smart card
personalization. A card is picked from the hopper, personalized,
and transported to the smart card module. See additional
information in Testing the Smart Card Option.
The Laminator Values dialog box is the interface for changing
the operational parameters of the laminator(s). For a
descriptions of the parameters, see Setting Laminator Values.
This dialog box provides information about the laminator
sensors. It also allows you to turn the heaters on and off
manually. See Viewing Laminator Sensors and Enabling Heaters.
This dialog box allows you to operate each of the motors in the
laminator for a specified duration. See Testing Laminator
Motors.
Purpose
Adjustments