Ribbon Index Sensor
Removal Procedure
1.
Turn off the printer and unplug the power cord.
2.
Remove the ribbon cartridge and cleaning roller.
3.
Remove the
4.
Optional: For easier access, you may choose to remove the
(page 6-53).
5.
Unplug the sensor from the main control board.
6.
Pull the sensor off the mounting post on the ribbon guide. Pry underneath
with a screwdriver if necessary.
Replacement Notes
•
Route the cable through the ribbon guide as shown below.
•
Refer to the
Connection Diagram for replacement details.
•
Use the sensor display in Diagnostics to verify the sensor changes state as the
ribbon is advanced.
CP80 and CP80 Plus Service Manual
Main Enclosure
(page 6-15).
Print Engine Front Wire Routing Diagram
Ribbon Guide
and
Print Engine Cable
6-29