Upper Foil Drive Assembly
Removal Procedure
1.
Turn off the printer and unplug the power cord.
2.
Remove the
3.
Disconnect the foil advance motor connector from the laminator control
board.
4.
Free up the following cables from the cable guides on the face of the drive
assembly:
Heater Lift Motor
•
•
Thermocouple
•
Heater
5.
Press in on the two retaining tabs and pull the assembly away from the
laminator chassis.
6-126
Main Enclosure
The two gears and the pressure spring on the back of the drive assembly
are not retained. Refer to the replacement notes for a picture and
description.
(page 6-15).
Removal and Replacement