Laminator RFID Antennas
Removal Procedure
1.
Turn off the printer and unplug the power cord.
2.
Remove the
3.
While lifting the retaining tab slightly, pull out on the circuit board.
4.
Disconnect the cable from the connector.
Replacement Notes
•
Refer to the
Connection Diagram
•
Go to the advance setup in the printer tool box to verify that the printer properly
identifies the laminate supply.
CP80 and CP80 Plus Service Manual
Main Enclosure
(page 6-15).
Laminator Front Wire Routing Diagram
for replacement details.
and
Laminator Cable
6-111