Konica Minolta bizhub 500 Service Manual page 156

Field Service Ver.2.0 Jan. 2007
B. During Firmware Updating
1.
The message to indicate the status will be displayed on the screen while connecting or transferring data.
C. Completed or failed
(1) Firmware updated normally
1. When the Firmware is normally updated, restart the Copier in auto or manual mode to display the outcome,
and touch [OK] to return to the Main screen.
Note
• When turning the main power switch (SW1) ON for the first time after the Firmware is updated,
data may sometimes be internally updated.
In that case, the following message will be displayed. Never turn SW1 OFF until either the Serial
number input screen or the trouble code screen is displayed.
(2) Failing to update the Firmware due to the Network trouble
1.
When updating failed to complete due to the trouble on connecting to the network, an error code and the
message will be displayed.
2.
Restart the Copier in auto or manual mode, and touch [OK]. It can be used with the Firmware Version before
conducting updating.
3.
Check the settings for the network by error codes, and try updating again.
Note
• For error codes, refer to
Confidential – for internal use only, do not distribute
"5.3.5 Error Code List for the Internet
5. FIRMWARE VERSION UP
ISW".
50gaf2e006ca
123
1