Konica Minolta bizhub 500 Service Manual page 281

10. SERVICE MODE
Step
Using the telephone line
modem
2 Clearing the RAM
1.
Select [Service Mode] → [CS Remove Care], and touch [Detail Setting].
2.
Touch [RAM Clear].
3.
Select Set, and touch [OK].
(See P.258)
3 Selecting the CS
Remote Care function
Select [Service Mode]
→ [CS Remove Care]
→ [System Selection],
and touch [Modem].
4 Inputting the ID Code
1.
Select [Service Mode] → [CS Remote Care] → [ID Code], and touch [ID Code].
2. Input the seven digits ID of the service person, and touch [ID Code] again.
(See P.257)
5 Setting the date and time for CS Remote Care
1.
Select [Service Mode] → [CS Remote Care], and touch [Detail Setting].
2.
Touch [Date & Time Setting].
3.
Input the date, time and the time zone using the 10-Key Pad, and touch [Set].
(See P.257)
6 Setting the Center ID
1.
Select [Service Mode] → [CS Remote Care], and touch [Detail Setting].
2.
Touch [Machine Setting] → [Center ID], and input the Center ID (five digits).
(See P.257)
7 Setting the Device ID
1.
Select [Service Mode] → [CS Remote Care], and touch [Detail Setting].
2.
Touch [Machine Setting] → [Device ID], and input Device ID (nine digits).
(See P.257)
8 Setting the telephone number of the Center
1.
Select [Service Mode] → [CS Remote Care],
and touch [Detail Setting].
2.
Touch [Machine Setting] → [Center Tele-
phone Number].
3.
Input the telephone number of the Center
using the 10-Keys Pad and [P], [T], [W], [-].
(See P.257)
9 Inputting the Device telephone number
1.
Select [Service Mode] → [CS Remote Care],
and touch [Detail Setting].
2.
Touch [Machine Setting] → [Device Tele-
phone Number].
3.
Input the Device telephone number using the
10-Key Pad and [P], [T], [W], [-].
(See P.257)
248
1
Using the Fax line
modem *1
Selecting the CS
Remote Care function
Select [Service Mode]
→ [CS Remove Care]
→ [System Selection],
and touch [Fax].
Confidential – for internal use only, do not distribute
Procedure
Using E-mail
Selecting the CS Remote Care function
Select [Service Mode] → [CS Remote Care] →
[System Setting], and touch [E-Mail].
Setting the Respond Timeout
1.
Select [Service Mode] → [CS Remote Care],
and touch [Detail Setting].
2.
Touch [Respond Timeout] and enter the
response timeout using the 10-Key Pad.
NOTE
• Under normal conditions, there is no
need to change the default setting.
(See P.257)
Proceed to Step 10.
Field Service Ver.2.0 Jan. 2007