Konica Minolta bizhub 500 Service Manual page 558

Field Service Ver.1.0 Feb. 2006
B. Stringing wires
[7] [6]
[6]
B
A A
[11] [8] [11] [8]
[10]
B
[2]
[1]
[9]
[12]
[13]
B
[2]
A
[1]
[5]
[6]
Confidential – for internal use only, do not distribute
[14] [15] [15]
C
D D
[16] [17] [16] [17]
[4]
C
D
[3]
A
[5]
[9]
[12]
[13]
16aaf2c027na
C
D
A
[3] [9] D [8]
[7]
C
B
[10]
[11]
[4] [4]
16aaf2c028na
1.
Pass the wire A [1], the wire B [2], the wire C [3]
and the wire D [4] through the lift plate [5].
2.
Run the wire A [6] and the wire B [7] through the 2
upper pulleys [8] and the 2 lower pulleys [9], and
then through the adjustment part [10].
3.
Tighten the 2 upper pulleys [8] with the 2 E-rings
[11].
4.
Install the wire stopper [12] to each of the 2 lower
pulleys [9] in the direction as shown in the draw-
ing. And then fasten it with the 2 E-Rings [13].
5.
Run the wire C [14] and the wire D [15] through
the groove of the pulley [16].
6.
Tighten the 2 pulleys [16] with each of the E-ring
[17].
7.
After putting the auxiliary wire [1], the wire A [2]
and the wire B [3] into the holes in the front sec-
tion of the drive shaft [4], install the drive pulley [5]
and tighten it with the E-ring [6].
8.
After putting the detection wire [7], the wire D [8]
and the wire C [9] into the holes in the rear section
of the drive shaft [4], install the drive pulley [10]
and tighten it with the E-ring [11].
3. OTHERS
19