Half-Fold Position (Sd-502) - Konica Minolta bizhub 500 Service Manual

Field Service Ver.2.0 Jan. 2007
10.9.2

Half-Fold Position (SD-502)

Adjusts the folding position while in the stitch-and-fold print by SD-502.
A. Procedure
1.
"Service Mode screen"
Press [Finisher].
2.
"Finisher Adjustment screen"
Press [Half-Fold Position].
3.
"Half-Fold Position Adjustment screen"
Press each key to select the paper size to be adjusted.
4.
Press [Test Copy].
5.
"Test Copy screen"
With the original set to DF, select a paper size and press the Start key.
6.
Press [END].
7.
Fold the output paper along the folding line and
check the paper edge to see if it is not shifted [1].
Standard value [1]: 0 ± 1.5 mm
8.
"Half-Fold Position Adjustment screen"
Enter a value through the [+]/[–] or numeric keys and press [Setting].
Setting range: – 5.0 (to the right) to + 5.0 mm (to the left)
1 step = 0.5 mm
Press [Restore] to return to the value before change.
NOTE
• When there occurs a shift shown at step 7, enter a value on the minus (–) side.
9.
Repeat steps 3 to 8 until it gets inside the standard value.
10.
Press [OK].
Confidential – for internal use only, do not distribute
10. SERVICE MODE
[1]
4511f3c006na
243