Adjusting The Tray Overload Detection Level - Konica Minolta bizhub 500 Service Manual

Field Service Ver.1.0 Feb. 2006
3.6

Adjusting the tray overload detection level

This adjustment is made when replacing the FS control board (FSCB) or replacing the tray lift motor (M7).
A. Procedure
Confidential – for internal use only, do not distribute
[1]
4521f3c014na
3. MECHANICAL ADJUSTMENT
1.
Set the output check mode "Main tray operation
mode."
(See P.17)
2.
Rotate VR2 [1] on the FS control board (FSCB)
counterclockwise up to the limit.
33