Image Position: Leading Edge (Scan Area) - Konica Minolta bizhub 500 Service Manual

Field Service Ver.2.0 Jan. 2007
10.3.6

Image Position: Leading Edge (Scan Area)

Adjusts the leading edge timing while in the scan in the platen mode.
This adjustment is used to adjust the position at which the read is started in the sub scan direction while the
original is being scanned by the exposure unit.
A. Procedure
1.
"Service Mode screen"
Press [Machine].
2.
"Machine Adjust screen"
Press [Scan Area].
3.
"Scan Area screen"
Press [Image Position: Leading Edge].
4.
"Scan Area (Image Position: Leading Edge) screen"
Press [Test Copy].
5.
"Test Copy screen"
With the test chart set on the original glass, select A3 (for metric) or 11 x 17 (for inch) paper and press the
Start key.
6.
Press [OK].
7.
Check the scanner leading edge position (original glass).
Standard value: a. Envelope 0 ± 2.5 mm or less
b. Other paper 0 ± 1.5 mm or less
8.
"Scan Area (Image Position: Leading Edge) screen"
Enter a value through the [+]/[–] or numeric keys and press [Setting].
Setting range: – 2.0 (shorter) to +2.0 mm (longer)
1 step = 0.1 mm
Press [Restore] to return to the value before change.
9.
Repeat steps 4 to 8 until it gets within the standard value.
10. Press [END].
Confidential – for internal use only, do not distribute
10. SERVICE MODE
185