17. Alignment
1
Image 17-38
Rotate image
3. Select Warp adaptation, angle.
4. Use the ◄ or ► key to change the rotation Angle.
Or,
press ENTER to open the Warping Adaptations window. Use the ◄ or ► key to change the Angle.
Image 17-39
Warping adaptation, angle
17.7.14 Hardware Reset
What can be done ?
During some combinations of adjustments, it is possible that the warping get stuck. Than it is possible to reset the board and restart
from a clean adjustment.
How to reset
1. Use the arrow keys to select the Reset icon on the general icon bar at the bottom of the Warp adjust window.
Image 17-40
Hardware reset
The hardware will restart. It can take a while until the warp unit is available again.
17.7.15 OSD opacity
About the opacity of the OSD menus
During the warp adjustment process the OSD menu is displayed on top the warp grid. To see the grid and the grid points, reduce
the opacity of the OSD menu.
192
2
3
R5906730 HDF WLP SERIES 01/08/2017