25.1.15 scan-dwell-time
Smart RF Instance
Sets the time in seconds to dwell on a channel during a channel scan
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
scan-dwell-time <1-10>
Parameters
scan-dwell-time <1-10>
Example
RFSwitch(config-wireless-smart-rf)#scan-dwell-time 10
RFSwitch(config-wireless-smart-rf)#
The duration in seconds to dwell on a channel during a
channel scan. The default scan dwell time value is 1
second. If the scan dwell time is increased, the same time
will be required to scan each channel which increases the
total calibration time thus causing the disruption of service
during that time.
Smart RF Instance
25-27