Motorola RFS6000 Reference Manual page 844

20-124 Motorola RF Switch CLI Reference Guide
• authentication-protocol [chap|pap] – Sets the RADIUS
Authentication Protocol for RADIUS request. Select from
CHAP or PAP
• dscp <0-63> – Specify a Differentiated Services Code
Point (DSCP) value to provide QoS to RADIUS packets. Set
a value in the range 0 to 63
• dynamic-authorization enable – Configures support for
RADIUS dynamic authorization extensions such as
Disconnect Message, and Change-Of-Authorization, as
described in RFC 3576
• enable – Enables this feature
• dynamic-vlan-assignment enable – Allow users to be
assigned to RADIUS server specified VLANs, instead of
only the vlan that is mapped to this wlan
• enable – Enables this feature
• mac-auth-format [no-delim|pair-colon|pair-dash|quad-
dot|middle-dash] – Set the MAC address format to use.
• middle-dash – Dash Delimiter in the middle -
AABBCC-DDEEFF
• no-delim – No Delimiter - AABBCCDDEEFF
• pair-colon – Colon Delimiter per Pair -
AA:BB:CC:DD:EE:FF
• pair-dash – Dash Delimiter per Pair -
AA-BB-CC-DD-EE-FF
• quad-dot – Dot Delimiter per Four Hex -
AABB.CCDD.EEFF
• mobile-unit timeout <1-300> retransmit <1-100> –
Modifies RADIUS/802.1X supplicant related parameters.
• timeout <1-300> – Sets the Time the wireless switch
waits for a response from the mobile-unit before
retrying. Set a value in the range 1 to 300
• retransmit <1-100> – Sets the number of retries before
the wireless switch will give up and disassociate the
mobile-unit. Set a value in the range 1 to 100