Configuring A Client - Motorola RFS6000 Reference Manual

20-28 Motorola RF Switch CLI Reference Guide

20.1.15.1 Configuring a Client

Refer to the configurations below to:
• Create an exclude list.
RFSwitch(config-wireless)#client exclude-list protected-hosts
RFSwitch(config-wireless-client-list)#
• Add a host entry into the exclude list.
RFSwitch(config-wireless-client-list)# station printers
00:00:AA:DD:EE:11/00:00:FF:DD:EE:11
RFSwitch(config-wireless-client-list)# station testing-host1
00:11:AA:03:1B:FE
• Associate the exclude list to a WLAN.
RFSwitch(config-wireless-client-list)# wlan 1
• Configure RADIUS server parameters
RFSwitch(config-wireless)# wlan 1 nac-server primary 192.168.0.1
RFSwitch(config-wireless)# wlan 1 nac-server primary secret 0
testing
RFSwitch(config-wireless)# wlan 1 nac-server secondary 192.168.1.1
RFSwitch(config-wireless)# wlan 1 nac-server secondary secret 0
testing123
• Enable NAC for a WLAN.
RFSwitch(config-wireless)# wlan 1 nac-mode do-nac-except-exclude-
list
• Undo a configuration.
RFSwitch(config-wireless)# client exclude-list protected-hosts
RFSwitch(config-wireless-client-client)# no station testing-host1
RFSwitch(config-wireless)# no client exclude-list protected-hosts
RFSwitch(config-wireless)# no wlan 1 nac-server primary
RFSwitch(config-wireless)# no wlan 1 nac-server primary secret
RFSwitch(config-wireless)# no wlan 1 nac-server secondary
RFSwitch(config-wireless)# no wlan 1 nac-server secondary
radius-key
RFSwitch(config-wireless)# no wlan 1 nac exclude-list
protected-hosts
.