Duplex - Motorola RFS6000 Reference Manual

12.1.4 duplex


Interface Config Commands
Specifies the duplex mode for the interface
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
duplex [auto|full|half]
Parameters
auto
full
half
Usage Guidelines
The duplex defines the communication used by the port. The switch (by default) is set in
the auto duplex mode. In auto mode, the duplex is selected based on connected network
hardware.
NOTE:
• Duplexity can only be set for an Ethernet Interface. Enter the
instance using the
(config-if)
mode
• The duplex cannot be set until the speed is set to a non-auto value
Sets the ports duplexity automatically. The port
automatically detects whether it should run in full or
half-duplex mode
Sets the port in full-duplex mode
Sets the port in half-duplex mode
Interface Instance
parameter of the
eth
12-7
interface