Motorola RFS6000 Reference Manual page 778

20-58 Motorola RF Switch CLI Reference Guide
20.1.38 no

Wireless Configuration Commands
Negates a command or sets its defaults. All the parameters mentioned in the syntax can
be negated using the
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
no [aap|admission-control|adoption-pref-id|
adopt-unconf-radio|ap|ap-containment|ap-detection|ap-image|
ap-ip|ap-standby-attempts-threshold|ap-timeout|ap-udp-port|
auto-select-channel|broadcast-tx-speed|client|
cluster-master-support|country-code|debug|
dhcp-one-portal-forward|dhcp-sniff-state|
dot11-shared-key-auth|fix-broadcast-dhcp-rsp|hotspot|ids|
mac-auth-local|manual-wlan-mapping|mobile-unit|mobility|
multicast-packet-limit|multicast-throttle-watermarks|nas-id|
nas-port-id|proxy-arp|qos-mapping|radio|rate-limit|
secure-wispe-default-secret|self-heal|
sensor|service|show|smart-rf|
smart-scan-channels|wips|wlan|wlan-bw-allocation]
Parameters
Refer to the individual commands for the parameters negated using the
Example
RFSwitch(config-wireless)#no mobility enable
RFSwitch(config-wireless)#
command.
no
command.
no