Aligning The Push Rollers - GRAPHTEC CE3000-40 User Manual

5
Step
Pressing the and
PRESS ENTR". Select "SHEET PRESS ENTR" and then press the
selection. When "SHEET PRESS ENTR" is selected, the front and rear edges are detected.
6
Step
After the medium size has been detected, the pen carriage returns to the origin point and the cutting plotter
awaits cutting data. If the INTERFACE conditions or COMMAND mode have not yet been set, they should
be set. If they have already been set, adjust the cutter pen. Once the cutter pen has been adjusted, the
cutting plotter is ready to perform cutting, so cutting data can be sent from the application software on the
computer.
I Aligning the Push Rollers
Adjust the position of the left- and right-hand push rollers to suit the medium width. Position the push roll-
ers at either edge of the medium so that they are above the grit rollers. Adjust the push rollers so that they
are positioned above both the medium and the grit rollers. Positioning the push rollers within the push-
roller alignment marks ensures that they are above the grit rollers.
Push-roller alignment mark
CAUTION To move the push rollers, the media set lever must be in the lowered position.
The push roller on the right-hand edge when viewed from the front must always be moved over the right-
hand wide grit roller.
keys displays "ROLL1 PRESS ENTR", "ROLL2 PRESS ENTR", and "SHEET
NG
OK
2 – 9
(ENTER) key to confirm the
NG
OK
Right-hand push roller
Right-hand grit roller