Setting Wear-Rate Groups - GRAPHTEC CE3000-40 User Manual

ISetting Wear-Rate Groups
F E E D
This registers setting areas in groups.
A U T O P R E F E E D
Step
T A N G E N T I A L
Press the
A U T O R E G . M A R K
C L E A R B U F F E R
Step
A X I S A L I G N M E N T
Press the
D I S T A N C E A D J U S T
P A G E L E N G T H
B L A D E W E A R S E T U P
P L O T A R E A
Step
E X P A N D
Press the
R O T A T E
C O P Y
S E T B L A D E G R O U P
S O R T
R S - 2 3 2 C
Step
C O M M A N D
Press the
B L A D E W E A R S E T U P
G R O U P
P E N U P / D O W N
T E S T M O D E
Step
P E N U P S P E E D
The number on the left is the group number, and the numbers to the right of this
O F F S E T F O R C E
indicate the setting areas belonging to it, separated by spaces. The display
above indicates setting areas 1, 2, 4, and 5, belonging to group 1.
O F F S E T A N G L E
Use the
S T E P P A S S
area number to be set. Pressing the
I N I T . D O W N F O R C E
increases or decreases the number, and pressing the
L E N G T H U N I T
ting-area number position displays or doesn't display the number. Select the
required group number, display the setting-area numbers to be registered, and
then press the
Each setting area can only be registered in one group. To register a setting area
in another group, it must first be removed from the group in which it is regis-
tered. Initially, setting area 1 is set to group 1, setting area 2 to group 2, and so
on, so setting areas must be removed from one group before being registered in
another.
To cancel, press the
1
(PAUSE) key to switch to PAUSE mode.
2
(NEXT) or (PREV.) key until the following menu is displayed.
3
(ENTER) key to display the wear-rate setting submenu.
4
(ENTER) key to display the wear-rate group setting.
1 1 2 4 5
5
and keys to move the cursor to the group number or setting-
(ENTER) key to confirm.
(NEXT) or
4 – 35
or key at the group-number position
or
(PREV.) key.
key at the set-