Aligning The Push Roller - GRAPHTEC CE6000-120AP Setup Manual

11
Raise the set lever after confirming that the route the roll paper passes through
is taut and not slackening. The push roller position and the roll paper will stay in
place.
12
Lowering the lever releases the stopper lock.
3. Aligning the Push Rollers
This section describes how to alignment of the push rollers.

Aligning the Push Roller

Position the left and right push rollers to correspond with the width of the media. Adjust the push rollers so that they are positioned above both
the media and the grit rollers.
Position the push rollers within the grit roller position guides ensures that they are above the grit rollers.
Push roller
Grit roller position guide
Grit roller
CAUTION
To move the push rollers, the media set lever must be in the lowered position.
Supplement
If a [confirming push roller point] message appears after setting the media and raising the media set lever, it means the right push
roller is not on the right grit roller, or that the left or center 3 push rollers are not on the proper grit roller. Make sure everything is
set correctly.
Media set lever
(It isn't on the grit roller.)
CAUTION
During a plotting or cutting operation, be sure
to keep your hands, hair, and so forth away
from the media stocker and collar.
(It isn't on the grit roller.)