Aligning The Push Rollers - GRAPHTEC CE5000-120AP User Manual

Setting up The Cutter Plotter

Aligning the Push Rollers

Adjust the position of the left- and right-hand push rollers to suit the medium width. Position the
push rollers at either edge of the medium so that they are above the grit rollers. Adjust the push
rollers so that they are positioned above both the medium and the grit rollers. Positioning the push
rollers within the push-roller alignment marks ensures that they are above the grit rollers.
CAUTION
To move the push rollers, the media set lever must be in the lowered position.
The push roller on the right-hand edge when viewed from the front must always be moved over the
right-hand wide grit roller.
CAUTION
To move the push rollers, the media set lever must be in the lowered position.
CHECKPOINT
If the "REALIGN ROLLERS" message is displayed when the medium is detected, either the right-hand
push roller is not positioned over the right-hand wide grit roller or the left-hand or center push roller is
not positioned over a grit roller. Check to confirm that they are positioned correctly.
2-10
Push-roller alignment mark
NG
OK
Media sensor
NG
OK
Right-hand push roller
Right-hand grit roller