Table of Contents
Advertisement
5
Step
Use the
and
keys to select "OFF," "2 POINT," or "3 POINT," and then press the
to confirm.
6
Step
When "2 POINT" or "3 POINT" is set, the sensors read the registration marks as soon as the medium is
loaded (media set lever raised), and the following is displayed.
M O V E T O R . M A R K
To cancel the registration-mark reading and perform the normal initialization operation, press the
GIN) key. The "ROLL2 PRESS ENTR," "ROLL1 PRESS ENTR," "SHEET PRESS ENTR" selection is dis-
played, allowing normal initialization to be performed.
7
Step
Move the cutter pen to the lower-right registration mark using the
and press the
(ENTER) key. The sensor reads between points 1 and 2 (and between 1 and 3 for 3-
point alignment), and the following is displayed.
X 0 0 3 0 8 . 9 0 0 3 0 8 . 9
CHECKPOINT
• If the registration-mark distance correction is set to "1 mm," "5 mm," or "10
• The registration marks are read in accordance with the registration-mark-detec-
The distance between X-axis registration marks (points 1 and 2) read by the cutting plotter is displayed on
the left. Enter the actual distance on the right. Move the cursor to the digit to be entered using the
keys, use the
and
key to confirm. For 3-point alignment, the distance between the Y-axis registration marks (points 1 to 3) is
also displayed and should be set in the same way. To cancel, press the
8
Step
Upon completion of alignment, the cutting plotter returns to READY mode.
mm," the alignment input screen is not displayed.
tion movement distance setting.
keys to increase or decrease the values, and then press the
,
4 – 10
(ENTER) key
,
, and
(POSITION) keys,
(NEXT) or
(PREV.) keys
(ORI-
and
(ENTER)
Advertisement
Table of Contents
