Setting The - GRAPHTEC CE3000-40 User Manual

4.9 Setting the PAGE LENGTH
This function sets the length of each page when long-axis cutting or plotting is performed using a roll
medium. This should be set for long-axis cutting or plotting exceeding 5 m in length. The default setting is
"5000 mm."
F E E D
A U T O P R E F E E D
T A N G E N T I A L
A U T O R E G . M A R K
C L E A R B U F F E R
A X I S A L I G N M E N T
D I S T A N C E A D J U S T
P A G E L E N G T H
P L O T A R E A
E X P A N D
R O T A T E
C O P Y
S O R T
R S - 2 3 2 C
C O M M A N D
B L A D E W E A R S E T U P
P E N U P / D O W N
T E S T M O D E
P E N U P S P E E D
O F F S E T F O R C E
O F F S E T A N G L E
S T E P P A S S
I N I T . D O W N F O R C E
L E N G T H U N I T
1
Step
Press the (PAUSE) key to switch to PAUSE mode.
2
Step
Press the (NEXT) or
P A G E L E N G T H
3
Step
Press the (ENTER) key to display the page-length menu.
L = 0 5 0 0 0 m m
Move the cursor to the digit to be changed using the
and keys to increase or decrease the setting, and then press the
key to confirm. To cancel, press the
4
Step
Press the (PAUSE) key to cancel PAUSE mode.
CHECKPOINT
• This setting is retained in the memory even when the
• The cutting plotter's distance precision is guaranteed for
• In the case of long-axis cutting, be particularly careful
• For long-axis cutting using roll media, pull out the length
(PREV.) key until the following menu is displayed.
(NEXT) or
power is turned off.
page-feed lengths of up to 5 meters, provided that the
following conditions are satisfied (CE3000-60/120).
Long-axis cutting over 5 meters is possible for lengths of
up to 50 meters in the feeding direction.
Guaranteed precision conditions:
–The cutting plotter is mounted on its stand.
–Graphtec-specified film is used with the stipulated set-
ting conditions.
Film: 3M plastic-backed film
Setting conditions: Cutter speed, 30 cm/s max; Quality,
1
when loading color adhesive-backed film. If the film is
loaded at even a slight angle, the film may come loose
from the rollers that hold it in place.
of the medium to be used, or use the pre-feed operation
(see "4.2 Setting the FEED function" and "4.3 Setting
AUTO PRE-FEED").
4 – 24
and keys. Use the
(ENTER)
(PREV.) key.