Table of Contents
Advertisement
9
Step
Move the cursor to the digit to be entered using the
or decrease the values (or display/don't display "-" for the space to the right of "="), and then press the
(ENTER) key to confirm. If there is no offset, simply press the
adjustment input is then displayed and should be set in the same way. To cancel, press the
(PREV.) key.
10
Step
Press the
(PAUSE) key to cancel PAUSE mode.
Adjusting the Registration-mark Reading Sensor (2)
This adjusts the position of the sensor for reading the registration marks by plotting crosshairs and then
reading them. First set both cutter pen conditions 1 and 2 to the same pen. Crosshairs are first plotted
using conditions 1 and read by the sensor. A second set of adjustment crosshairs is plotted using condi-
tions 2. The difference between the two is input to adjust the position.
1
Step
Load a medium into the cutting plotter.
2
Step
Set both cutter pen conditions 1 and 2 to the same "Pen" (refer to "3.3 Setting the Cutter-Pen Conditions"),
and load a pen in the cutting plotter.
3
Step
Press the
(PAUSE) key to switch to PAUSE mode.
4
Step
Press the
(NEXT) or
A U T O R E G . M A R K
5
Step
Press the
(ENTER) key to display the Auto Reg. Mark submenu, and then press the
(PREV.) key until the following menu is displayed.
M A R K S E N S O R A D J 2
(PREV.) key until the following menu is displayed.
4 – 17
and
keys, use the
(ENTER) key. The Y-axis distance-
Crosshairs first plotted
Distance adjustment X
Distance
Adjustment crosshairs
adjustment Y
and
keys to increase
(NEXT) or
X
Y
(NEXT) or
Advertisement
Table of Contents
