Control Panel; Indicator Lamp - GRAPHTEC CE3000-40 User Manual

I Control Panel

Indicator Lamp

STATUS: Illuminates while the power to the cut-
ting plotter is turned on, and goes out
when the cutting plotter is in PAUSE
status. This lamp flashes when data is
being received from an interface,
regardless of whether or not the cutting
plotter is in PAUSE status.
Panel Keys
TEST: Press this function key to conduct a cut-
ting test and check the cutting condi-
tions.
PREV.: Press this function key to view the previ-
ous display on the LCD when in PAUSE
status.
NEXT: Press this function key to view the next
display on the LCD when in PAUSE sta-
tus.
COND.: Press this function key to view the cut-
ter-pen condition settings.
PAUSE: Press this function key once in READY
status to switch to PAUSE status in
order to change the various settings.
Press it again to cancel the PAUSE sta-
tus. Pressing this key while cutting or
plotting is in progress stops the cutting
or plotting.
ENTER: Pressing this function key registers the
cutting or plotting conditions set.
POSITION:
These keys are used to move the cursor
or change the settings on the LCD dis-
play on the function setting screens.
Press these keys when in PAUSE status
to move the pen carriage or the
medium.
ORIGIN: Press this function key to set the origin
point. The pen position is set as the ori-
gin point when this key is pressed.
1 – 6