Table of Contents
Advertisement
2
Step
Select the setting area (condition number) to be set, and move the
using the
or
key.
2
0 9 U + 1 2 3 3 0 2
3
Step
Press the
or
key to select "09U," "15U," "15B," or "PEN." Once set, press the
other conditions are to be set, press the
I Setting OFFSET
This setting adjusts the offset of the cutter blade to suit the blade type used. The tip of the blade mounted
in the cutter-pen plunger is not positioned at the center of the pen, so correction is required. This correction
is referred to as the OFFSET setting. The cutting plotter has been preset with OFFSET values for each cut-
ter-blade type. Selecting "09U," "15U," or "15B" for the PEN TYPE setting also sets the appropriate OFF-
SET, allowing fine adjustment within the range of ±5. When the "PEN" setting is selected, the OFFSET
cannot be set.
1
Step
Press the
(COND.) key in READY mode to display the cutter-pen conditions.
2
Step
Select the setting area (condition number) to be set, and move the
using the
or
key.
2 0 9 U
+ 1 2 3 3 0 2
3
Step
Press the
or
key to select the value to be changed in the range of "-5" to "+5." Once set, press the
(ENTER) key. If other conditions are to be set, press the
parameter to be set.
I Setting FORCE
Sets the pressure applied by the cutter pen during cutting. Set the FORCE value based on the guidelines
in the table entitled "Optimal Cutting Conditions for Each Media Type" on page 3-5.
1
Step
Press the
(COND.) key in READY mode to display the cutter-pen conditions.
2
Step
Select the setting area (condition number) to be set, and move the
using the
or
key.
2 0 9 U + 1
2 3 3 0 2
or
key to move the
or
3 – 7
symbol to the position shown below
(ENTER) key. If
symbol to the parameter to be set.
symbol to the position shown below
key to move the
symbol to the
symbol to the position shown below
Advertisement
Table of Contents
