Registration-Mark Pattern - GRAPHTEC CE3000-40 User Manual

The registration-mark conditions that can be read by the cutting plotter are as follows.
• Registration-mark line width: 0.3 mm to 1.0 mm (The registration-mark center lines are used as the ref-
erence points.)
• Registration-mark size: 5 mm to 20 mm (See "Setting the Registration-mark Size.")
• Registration-mark pattern: Pattern 1 or 2 (See "Setting the Registration-mark Pattern.")
• Registration marks must be formed of single lines.
• Registration marks must be drawn in black.
The cutting plotter cannot detect registration marks on the following media types.
• Transparent media:
• Non-monochrome drawings: The registration marks cannot be read on colored media or if the registra-
• Untidy drawings or media:
• Medium thickness:
CHECKPOINT
• The registration marks used in the application software cannot be used. The reg-
• If auto mark reading is not possible, use the axis alignment function (see "Setting

Registration-mark pattern

The cutting plotter is capable of reading the following registration-mark patterns.
The writing surface is also read, preventing the registration-mark lines
from being read.
tion marks are not black.
The registration marks cannot be read if the medium surface is dirty or
creased, or if the registration marks are defaced.
The registration marks cannot be read if the medium is more than 0.3 mm
in thickness.
istration marks must always be created as drawing data.
Axis Alignment").
Registration-mark pattern 1 Registration-mark pattern 2
4 – 7
X
Y